There are various problems in the production and processing of silicone products. In addition to the bad factors, the sticking of silicone products is the key problem that mainly affects the production efficiency and quality. I have explained the basic reasons and solutions for sticking. method, then what methods are needed for deeper processing methods?

In terms of technical level, it is mainly to improve the mold and the machine of the silicone product manufacturer for deployment, and try to improve the demoulding effect. Because different raw material silicone manufacturers have different preparation methods, and the performance parameters of the products are different, then the use of chemical release agents can certainly achieve better results, so how to use release agents correctly?

 

Common external mold release agent

This method is mainly used in the customization process of silicone products, after the mold is released, sprayed into the mold surface in the form of liquid spray, so that the surface of the mold has lubricity, and the product will naturally get a good effect during processing. It is mainly used in The surface interface layer of two objects that can be weakened with each other makes the product and the mold have a certain isolation layer, so that it is easy to separate! The main processing method is external, and the production and processing have no effect on the product!

 

Internal demoulding

The inner release agent has the same function as the outer release agent, but the difference is that it is an auxiliary agent added to the silicone rubber product compound. The product reduces the adhesion to the mold cavity, and this operation method may cause unnecessary effects on the product in the post-process. Due to the internal demoulding and high-viscosity silicone oil, whitening may occur in a long-term heated environment. The product is easy to lose oil and odor, but it mainly depends on how you control it. Since it is added according to the percentage, generally it cannot exceed 3%, so the reasonable addition will be effective for production efficiency, and the unreasonable addition will cause negative effects